Michell tone arms

 Part No.  TecnoArm
 Description  Michell TecnoArm
 Brand  Michell Engineering
 RRP  $ 1599
 Image Image
 Product Notes TECNO ARM "A" - in silver finish to fit all Michell turntables - Rega mounting

 chnArm

The Tecno Arm “A” is a fundamental mechanical rebuild of the well-known RB250 tonearm, to which is added monolithic wiring of the highest quality. The arm tube is bead-blasted and perforated, which disperses structural resonances and yields a lower effective mass. The arm wand is internally damped to reduce resonance further, and the headshell is machined flat, to allow true azimuth relative to the bearing cradle. After modification the bearings are re-adjusted for highest possible performance, according to original Rega procedures.

  • One-piece perforated arm casting with internal foam damping
  • Proprietary silver litz cable in a continuous run from cartridge to amplifier
  • PTFE dielectric, metal braided shielding, separate ground wire
  • Silver-plated cartridge clips and phono plugs
  • Two counterweights, matching cartridges of 4-7g and 7-13g
  • Vertical tracking force adjuster in steps of 0.1g
  • Vertical tracking angle adjuster
  • Finger locknut for easy arm removal or VTA adjustment

 

Part No.  Tecweight
 Description  Michell Tecno Arm Weight assy
 Brand  Michell Engineering
 RRP  $ 219
 Image Image
 Product Notes Arm weight for Tecno arm only

 

 Technoweight

Set of two counterweights, metal endstub, and precise 0.1g Vertical Tracking Force adjuster for Rega RB-250 and RB-300 tonearms and their derivatives. One counterweight matches cartridges of 3 to 6g mass, the other is for cartridges of 7 to 13g. The center of mass is at the stylus level, thereby increasing tracking and reducing record wear.

 

PRo-Ject TOnE ARMS

 
9cc
9cc


10cc
10cc


12cc
12cc


9cc Evolution
9cc Evolution


10cc Evolution
10cc Evolution


12cc Evolution
12cc Evolution